| Problem |
Cause |
Solution |
| Coatings peels. |
Coating is too thick. |
Dilute coating so that the layer thickness does not exceed 100µm. |
| Coating does not adhere on the surface. |
Bad surface conditions. |
Clean and degrease surface, perhaps grit blasting, warm surface
prior to application to 100-150°C. |
| Further layers do not stick on the first layer. |
First coating is not yet completely dried. |
Extend drying time, remove loose particles and coat again. |
| Exfoliation and cracking. |
Coating is too thick. |
Dilute coating in such way that thinner layers can be applied. |
| Cloudy, uneven application when spraying. |
Coating is not stirred up, spray gun is led jerkily not homogenious. |
Stirr coating or use mixer. Pull even courses with spray gun. |
Application procedures - error table
